Bonnet Scoops

Hand-Laid Woven FRP Bonnet Scoops

Browse our range of hand-laid woven fibreglass reinforced plastic (FRP) bonnet scoops manufactured by Monkey Warehouse in Brisbane. Designed for enthusiasts, restorers, and custom vehicle builders, these bonnet-mounted styling and airflow components utilise woven fibreglass reinforcement and thermoset composite construction for repairability, modification flexibility, and professional body shop preparation.

Bonnet scoops are commonly used to enhance vehicle styling, complement factory body lines, and in some applications assist with airflow management around the engine bay. Accurate contours, mounting surfaces, and profile consistency are important considerations during manufacturing and installation.

Aftermarket bonnet scoops may be manufactured using a variety of materials including thermoplastics, polyurethane, and fibreglass reinforced plastic (FRP). Material selection, tooling quality, wall thickness, and manufacturing controls can influence surface finish quality, dimensional consistency, and fitment preparation requirements.

As exterior components mounted directly above the engine bay, bonnet scoops are exposed to temperature fluctuations, UV exposure, vibration, and everyday environmental conditions. Material behaviour can vary depending on polymer formulation, reinforcement content, wall thickness, and manufacturing quality.

Monkey Warehouse bonnet scoops are manufactured using hand-laid woven fibreglass reinforced plastic (FRP) laminates. Woven glass fibres are combined with a thermoset resin matrix to create a composite laminate structure that can be repaired, reinforced, reshaped, and refinished using conventional fibreglass repair techniques.

Unlike chopped-strand or spray-up laminates, woven reinforcement provides controlled fibre orientation throughout the laminate. This manufacturing method supports consistent laminate construction, predictable repairability, and professional body shop preparation for restoration, motorsport, and custom vehicle applications.

• Hand-Laid Woven FRP Construction: Manufactured using woven fibreglass reinforcement and thermoset composite laminates.
• Repairable Composite Design: Suitable for localised reinforcement, reshaping, and refinishing using conventional fibreglass repair techniques.
• Bonnet Profile Integration: Designed to complement factory bonnet contours and support professional fitment preparation.
• Woven Fibre Architecture: Controlled fibre orientation throughout the laminate compared with traditional chopped-strand construction.
• Australian Manufactured: Produced locally by Monkey Warehouse in Brisbane, Queensland.

Shop our collection of fibreglass bonnet scoops, FRP bonnet vents, bonnet intake scoops, and vehicle-specific bonnet styling components available for Australia-wide shipping or warehouse collection.